LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 6.2L - Repair Instructions (1 Of 2)) >> Repair Instructions >> Valve Stem Oil Seal and Valve Spring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the valve rocker arms as needed. Refer to Valve Rocker Arm and Push Rod Replacement .
  2. Remove the spark plugs as needed. Refer to Gas Engine Ignition Spark Plug Replacement .
  3. GM476770Courtesy of GENERAL MOTORS COMPANY

    Install the J - 22794  adapter into the spark plug hole.

  4. Connect a shop air supply hose and apply compressed air in order to hold the valves in place.
  5. GM218211Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Completely engage the J 38606 jaws on the valve spring. The J 38606 may slip off and scratch the valve spring. Replace the valve spring if the valve spring becomes scratched.

    Use J 38606  compressor.

  6. Apply steady pressure on the valve spring cap until the valve keys are accessible.
  7. GM480555Courtesy of GENERAL MOTORS COMPANY

    Remove the valve keys (1).

  8. Carefully release the valve spring tension.
  9. Remove the J-38606  compressor.
  10. Remove the valve spring cap (2) and valve spring (3).
  11. Remove the valve stem oil seal (4).
scientia non olet · About LEMON Manuals