Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Valve Rocker Arm Cover - Install - Valve Rocker Arm Cover Installation - Right Side
- Wiring Harness Connector @ Ignition Coil - Connect [4x]
- Spark Plug Wire @ Ignition Coil - Connect [4x]
- Install the oil level indicator and tube. Refer to Oil Level Indicator Tube Replacement (LT4)
Valve Rocker Arm Cover Insulator (2) - Install - Valve Rocker Arm Cover Insulator Replacement - Right Side (LT4)
NOTE:
Note the location and routing of the wiring harness to ensure proper reinstallation.