Removal Procedure
WARNING: This page is about a different variant/trim than selected.
Valve Rocker Arm Cover Insulator (2) - Remove - Valve Rocker Arm Cover Insulator Replacement - Left Side (LT4)
- Spark Plug Wire @ Ignition Coil - Disconnect [4x]
- Wiring Harness Connector @ Ignition Coil - Disconnect [4x]
Valve Rocker Arm Cover Bolt (1) - Remove [10x]
- Valve Rocker Arm Cover (2) - Remove
- Valve Rocker Arm Cover Gasket (3) - Remove and DISCARD
- Valve Rocker Arm Cover (2) - Clean and inspect - Valve Rocker Arm Cover Cleaning and Inspection
NOTE:
Note the location and routing of the wiring harness to ensure proper reinstallation.