LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 6.2L - Repair Instructions (1 Of 2)) >> Repair Instructions >> Valve Lifter Oil Manifold Replacement (LT4) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE:

All gasket surfaces should be free of oil or other foreign material during assembly.

  1. GM2892820Courtesy of GENERAL MOTORS COMPANY

    Install a NEW gasket (1) on the valve lifter oil manifold.

  2. Set the valve lifter oil manifold (2) onto the engine.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the valve lifter oil manifold bolts (3).

    Tighten

    1. First pass in sequence 15 N.m (11 lb ft).
    2. Final pass in sequence 30 N.m (22 lb ft).
  4. GM4066741Courtesy of GENERAL MOTORS COMPANY

    Connect the two electrical connectors (1).

  5. Install the fuel injection fuel rail assemblies. Fuel Injection Fuel Rail Assembly Replacement - Bank 1 (LT4) , and Fuel Injection Fuel Rail Assembly Replacement - Bank 2 (LT4) .
  6. Install the fuel pump. Fuel Pump Replacement (LT4) .
scientia non olet · About LEMON Manuals