Single Use Fasteners and Components
WARNING: This page is about a different variant/trim than selected.
- Drivetrain and Front Suspension Cradle Front Bolt [2x]
- Drivetrain and Front Suspension Cradle Interior Bolt [2x]
- Drivetrain and Front Suspension Cradle Rear Bolt [2x]
- Engine Mount Bolt [2x]
- Front Lower Control Arm Front Bolt [2x]
- Front Lower Control Arm Rear Bolt [2x]
| Callout | Component Name |
|---|---|
| Preliminary Procedure Drivetrain and Front Suspension Cradle Replacement (LT1, LT4) |
|
| 1 | Engine Mount Bolt [2x]
CAUTION:
Refer to Fastener Caution .
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. Procedure
Tighten
|
| 2 | Engine Mount |
| 3 | Phenolic Spacer
CAUTION:
Phenolic spacer must be present to prevent galvanic/corrosive reaction and/or excessive temperature conduction between engine mount bracket and engine mount. Replace mount if phenolic spacer is missing or damaged. Failure to ensure phenolic spacer is intact and not damaged can lead to premature failure of engine mount and/or engine mount bracket. Procedure Inspect the engine mount to ensure the plastic spacer is in place and not damaged. |