Clutch Pilot Bearing Removal

Special Tools

• GE-2619-01  Slide Hammer
• GE-23907  Slide Hammer with Bearing Adapter
• GE-23907-1  Slide Hammer

For equivalent regional tools, refer to Special Tools .

1. Courtesy of GENERAL MOTORS COMPANY

   NOTE:

   GE-23907-1  slide hammer was part of the GE-23907  slide hammer with bearing adapter set. The adapter is still available as GE-23907  adapter.

   Remove the clutch pilot bearing using the GE-23907  adapter (1) and GE-23907-1  slide hammer (2).

   1. Install the legs of the GE-23907  adapter (1) into the clutch pilot bearing.
   2. Rotate the shaft of the tool until the legs of the tool are snug and contacting the I.D. surface of the bearing.
   3. Install the GE-23907-1  slide hammer (2) to the GE-23907  adapter (1).
   4. Remove the bearing from the rear of the crankshaft.
   5. Remove the special tools from the bearing.

2. Courtesy of GENERAL MOTORS COMPANY

   Discard the bearing.