Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Component Fastener Tightening Caution .

CAUTION:
The camshaft position actuator solenoid valves must be kept parallel to the engine front cover during removal and installation. The camshaft position actuator solenoid valves can be damaged if they become wedged or stuck during this process.

NOTE:
It is possible to push the camshaft rearward when installing the CMP actuator Valve. Be careful not to push the camshaft while installing the CMP actuator valve.

Install and tighten the NEW camshaft position actuator solenoid valve (1).
1. First pass: 65 N.m (48 lb ft)
2. Final pass: Tighten 90 degrees using J-45059 Angle Meter.
Courtesy of GENERAL MOTORS COMPANY

Remove the EN-42386-A flywheel holding tool (2) and bolts.
Install the starter - Starter Replacement (LT1, LT4) .
Install the camshaft position actuator magnet - Camshaft Position Actuator Magnet Replacement (LT4) , or Camshaft Position Actuator Magnet Replacement (LT1) .