Manifold Absolute Pressure Sensor Replacement
WARNING: This page is about a different variant/trim than selected.
NOTE:
Callouts in the following chart represent components shown in graphic above.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Upper Intake Manifold Cover Replacement |
|
| 1 | Electrical Connector |
| 2 | Manifold Absolute Pressure Sensor Fastener
CAUTION:
Refer to Fastener Caution . Tighten 5 N.m (44 lb in) |
| 3 | Manifold Absolute Pressure Sensor |
| 4 | Manifold Absolute Pressure Sensor Seal
NOTE:
Inspect the O-ring and replace if necessary. |