Knock Sensor 2 Replacement
WARNING: This page is about a different variant/trim than selected.
NOTE:
Callouts in the following chart represent components shown in graphic above.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Starter Replacement (LT1, LT4) , or Starter Replacement (LGX) , or Starter Replacement (LTG) . |
|
| 1 | Knock Sensor Fastener
CAUTION:
Refer to Fastener Caution . Tighten 25 N.m (18 lb ft) |
| 2 | Knock Sensor Procedure Disconnect the electrical wiring harness connector from the knock sensor. |