Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

NOTE:
If a new sensor is not being installed, inspect the camshaft sensor seal (2) and replace as needed.

Install the camshaft position sensor (1) into the engine front cover.
Courtesy of GENERAL MOTORS COMPANY

Position the camshaft position sensor bracket (1) in place.
Courtesy of GENERAL MOTORS COMPANY

Connect the and the engine wiring harness connector (1), oil pump flow control valve connector (2), camshaft position actuator solenoid connector (3), camshaft position sensor connector (4).
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Install the camshaft position sensor bracket fasteners (1) and tighten to 25 N.m (18 lb ft).
Air Conditioning Compressor Belt - Install - Air Conditioning Compressor Belt Replacement
Air Cleaner Outlet Duct - Install - Air Cleaner Outlet Duct Replacement (LT4)