Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Air Cleaner Resonator-Air Cleaner Outlet Duct to Engine - Remove - Air Cleaner Resonator Replacement (Air Cleaner Outlet Duct to Engine)
Remove the drive belt. Drive Belt Replacement - Accessory (LT1)
Courtesy of GENERAL MOTORS COMPANY

Disconnect the engine wiring harness connector (1), oil pump flow control valve connector (2), camshaft position actuator solenoid connector (3), and camshaft position sensor connector (4).
Courtesy of GENERAL MOTORS COMPANY

Remove the camshaft position sensor bracket fasteners (1) from the engine block.
Courtesy of GENERAL MOTORS COMPANY

Reposition the camshaft position sensor bracket and sensor wiring harness (1).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
If reinstalling the original camshaft position sensor, inspect the seal (2) for wear and replace as needed. Always install the NEW seal supplied with the new camshaft position sensor.

Remove the camshaft position sensor (1) from the engine front cover.