Circuit/System Verification
- Vehicle in Service Mode.
- Verify that no other DTCs are set.
- If any other DTCs are set
- Go to next step: If none of the DTCs are set
- Verify that DTC P1F17 is not set.
- If DTC P1F17 is set
- Verify the K36 Inflatable Restraint Sensing And Diagnostic Module is programmed with the correct software calibration.
- If the correct software is not installed, program the K36 Inflatable Restraint Sensing And Diagnostic Module.
- Go to next step: If the correct software is installed
- Perform the Clear Secured High Voltage DTCs repair instruction.
- Verify that DTC P1F17 does not set while operating the vehicle within the Conditions for Running the DTC.
- If DTC P1F17 is set, replace the K114B Hybrid Powertrain Control Module 2.
- Go to next step: If DTC P1F17 is not set
- All OK.
- Go to next step: If DTC P1F17 is not set
- All OK.