Repair Instructions

Perform the Diagnostic Repair Verification after completing the repair.

• 300-Volt Battery Positive and Negative Cable Replacement (Generator Battery Control Wiring Junction Block to Drive Motor Battery)
• Battery Charger Control Module Replacement for T18 Battery Charger replacement.
• Accessory DC Power Control Module Replacement for K1 14 V Power Module replacement.
• High Voltage Battery Disconnect Relay Fuse Replacement for T18 battery charger fuse replacement.
• Hybrid/Electric Vehicle Battery Disconnect Relay Replacement for A28 hybrid/EV battery contactor assembly replacement.
• Control Module References for T6 Power Inverter Module and T24 Battery Charger-DC replacement, programming and setup.