Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P10BC

The following parameters are not within 15 kPa (2.3 PSI) of each other:

The above condition (s) must occur for greater than 5 s.

P2228

BARO Sensor 1 = Less than 50 kPa (7.25 PSI) For greater than 4 s

P2229

BARO Sensor 1 = Greater than 115 kPa (16.7 PSI) For greater than 4 s

P2230

BARO Sensor 1 = Signal noisy or erratic - For greater than 4 s

P227C

BARO Sensor 2 = Less than 50 kPa (7.25 PSI) For greater than 4 s

P227D

BARO Sensor 2 = Greater than 115 kPa (16.7 PSI) For greater than 4 s

P227E

BARO Sensor 2 = Signal noisy or erratic - For greater than 4 s