LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Blazer RS, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Throttle Body Assembly Replacement >> Single Use Fasteners and Components

Single Use Fasteners and Components

WARNING: This page is about a different variant/trim than selected.

Throttle Body Seal [2x]

GM5049247Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Lifting and Jacking the Vehicle
  2. Charge Air Cooler Outlet Air Hose @ Throttle Body - Remove - Charge Air Cooler Outlet Air Hose Replacement 
1 Throttle Body Bolt [3x]
CAUTION:

Refer to Fastener Caution .


Tighten 
8.5 N.m (75 lb in)
2 Throttle Body Adapter
3 Throttle Body

Procedure

  1. Disconnect the electrical connectors.
  2. Install NEW throttle body gasket/seals.
  3. Perform the throttle body idle air flow compensation reset. Throttle Body Idle Air Flow Compensation Reset 
scientia non olet · About LEMON Manuals