Single Use Threaded Fastener/Component Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Automatic Transmission Flex Plate Bolt | Automatic Transmission Flex Plate Replacement |
| Balance Shaft Sprocket Bolt | |
| First Pass: | 58 N.m (43 lb ft) |
| Final Pass: | 45 degrees |
| Camshaft Sprocket Bolt | |
| First Pass: | 50 N.m (37 lb ft) |
| Final Pass: | 28 degrees |
| Catalytic Converter Clamp | 15 N.m (11 lb ft) |
| Connecting Rod Bearing Cap Bolt | |
| First Pass: | 25 N.m (18 lb ft) |
| Final Pass: | 75 degrees |
| Crankshaft Balancer Bolt | |
| First Pass: | 150 N.m (111 lb ft) |
| Final Pass: | 140 degrees |
| Crankshaft Bearing Cap Bolt | Crankshaft and Bearing Removal and Installation |
| Cylinder Head Bolt | Cylinder Head Replacement |
| Engine Mount Bracket Bolt | |
| First Pass: | 58 N.m (43 lb ft) |
| Final Pass: | 60-75 degrees |
| Fuel Feed Intermediate Pipe Nut | 30 N.m (22 lb ft) |
| Oil Filter | 3/4 to 1 full turn after gasket makes contact with the sealing surface on the filter mounting flange |
| Timing Chain Tensioner Shoe Bolt | 15 N.m (11 lb ft) |
| Turbocharger Bolt | Compressor Air Intake Turbocharger Replacement |