Removal Procedure
WARNING: This page is about a different variant/trim than selected.
Drain the engine oil. Engine Oil and Oil Filter Replacement
Automatic Transmission Flex Plate (1) - Remove - Automatic Transmission Flex Plate Replacement
- Crankshaft Position Sensor Inner Exciter Ring - Remove - Crankshaft Position Sensor Inner Exciter Ring Replacement
Crankshaft Position Sensor (2) - Remove - Crankshaft Position Sensor Replacement
Crankshaft Rear Oil Seal Housing Bolt (1) - Remove [13x]
- Loosen the crankshaft rear oil seal housing carefully from the engine block, use a suitable tool to pry all the way around.
- Crankshaft Rear Oil Seal Housing (2) - Remove and DISCARD
NOTE:
It is likely you will bend the housing during removal. Use care to not damage the engine block.