Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Coat all bearing surfaces with clean engine oil.

Exhaust Camshaft (1) - Install
Intake Camshaft (2) - Install
Courtesy of GENERAL MOTORS COMPANY

Ensure that the camshaft notch (2) at the front of the camshaft (1) is in the 6 o'clock position.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Coat all bearing surfaces with engine oil.

Camshaft Bearing Cap (1, 2, 3) - Install
Courtesy of GENERAL MOTORS COMPANY

Camshaft Bearing Cap Bolt (1) - Install and hand tighten [26x]
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Camshaft Bearing Cap Bolt (1) - Tighten in sequence [26x]
1. First Pass: 8 N.m (71 lb in)
2. Second Pass: Loosen bolts 60 degrees, use the EN-45059 Angle Meter
3. Final Pass: 10 N.m (89 lb in)
Courtesy of GENERAL MOTORS COMPANY

EN-52462-A Camshaft Tool (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Camshaft Carrier (1) - Install - Camshaft Carrier Replacement