Removal Procedure
WARNING:
The battery must be disconnected to prevent the brake master cylinder from pressurizing the hydraulic system during its automated self diagnostic tests that can possibly occur when a door is opened or the key transmitter is activated. Failure to follow this precaution may cause personal injury.
WARNING:
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation
- Rear Wheelhouse Liner - Remove - Rear Wheelhouse Liner Replacement
Rear Brake Pipe Fitting (1) @ Brake Pipe Union (2) - Remove
- Cap the brake pipe union to prevent fluid loss and contamination.
- Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Brake Pipe Clip (1) - Release
- Brake Pipe Clip Clip (2) - Release
Rear Brake Pipe Fitting (1) @ Rear Brake Hose (3) - Remove
- Cap the brake pipe fitting to prevent brake fluid loss and contamination.
- Rear Brake Hose Retainer (2) - Remove
Brake Pipe Clip (1) - Release [3x]
- Rear Brake Pipe (2) @ Vehicle - Remove