Removal Procedure
WARNING:
The battery must be disconnected to prevent the brake master cylinder from pressurizing the hydraulic system during its automated self diagnostic tests that can possibly occur when a door is opened or the key transmitter is activated. Failure to follow this precaution may cause personal injury.
WARNING:
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Battery Tray - Remove - Battery Tray Replacement
- Raise and support the vehicle. Lifting and Jacking the Vehicle .
- Remove the front tire and wheel assembly. Tire and Wheel Removal and Installation
Brake Pressure Modulator Valve Front Brake Pipe Fitting (1) @ Brake Pressure Modulator Valve - Remove
- Plug the brake pressure modulator valve port to prevent brake fluid loss and contamination.
- Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Brake Pressure Modulator Valve Front Brake Pipe Fitting (1) @ Front Brake Hose (3) - Remove
- Cap the brake pipe fitting to prevent brake fluid loss and contamination.
- Front Brake Hose Retainer (2) - Remove
Brake Pressure Modulator Valve Front Brake Pipe Clip (1) - Release
- Brake Pressure Modulator Valve Front Brake Pipe (2) @ Vehicle - Remove