LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Trailblazer RS, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls And Fuel - 1.0L (L4B L4F L4G LIJ) Or 1.2L (L4H L4K LIF LIH) - Diagnostic Information And Procedures (1 Of 2)) >> Diagnostic Information and Procedures >> DTC P0351-P0353, P2300, P2301, P2303, P2304, P2306, or P2307 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Engine - Running
  2. Verify the scan tool parameter:
    • Ignition Coil 1 - 3 Control Circuit High Voltage Test Status = OK or Not Run
    • Ignition Coil 1 - 3 Control Circuit Low Voltage Test Status = OK or Not Run
    • Ignition Coil 1 - 3 Control Circuit Open Test Status = OK or Not Run
    • If not the specified state 

      Refer to Circuit/System Testing

    • Go to next step: If the specified state 
  3. Verify the scan tool parameter:
    • Ignition Coil 1 - 3 Control Circuit High Voltage Test Status = OK or Not Run
    • Ignition Coil 1 - 3 Control Circuit Low Voltage Test Status = OK or Not Run
    • Ignition Coil 1 - 3 Control Circuit Open Test Status = OK or Not Run
    • Perform the action while monitoring the parameter:
    • Wiggle the harness and connector: T8 Ignition Coil
    • Wiggle the harness and connector: K20 Engine Control Module
    • If not the specified state 

      Repair as necessary - Wiring/Terminal(s)/Electrical Connector(s)

    • Go to next step: If the specified state 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to Circuit/System Testing

    • Go to next step: If the DTC is not set 
  5. All OK.
scientia non olet · About LEMON Manuals