Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Transmission Fluid - Drain - Transmission Fluid Drain and Fill (L3T)
- After removing the related parts for the powertrain assembly removal, remove the powertrain assembly from the vehicle. Engine Replacement
Unclip the transmission vent hose retainer (1) and the wiring harness retainer (2).
- Disconnect the electrical connector (3).
Disconnect the control valve body transmission control module electrical connector (1), then unclip the wiring harness retainer (2).
Transmission Wiring Harness Bracket Nut (1) - Remove [3x]
- Transmission Wiring Harness Bracket (2, 3, 4) - Remove [3x]
Automatic Transmission Fluid Cooling Exchanger Bolt (1) - Remove [3x]
- Automatic Transmission Fluid Cooling Exchanger (2) - Remove
Heater Outlet Pipe (1) - Remove - Heater Outlet Pipe Replacement
Transmission Bolt (1) - Remove [2x]
- Starter - Remove - Starter Replacement (L3T)
- Mark the relationship of the flywheel to the torque converter for reassembly.
Torque Converter Bolt (1) - Remove and DISCARD [3x]
Transmission Bolt (1) - Remove
Transmission Bolt (1) - Remove
Transmission Bolt (1) - Remove [3x]
- Transmission Converter Cover (2) - Remove
- Separate the transmission from the engine.
- Transfer components as necessary.
NOTE:
Ensure the torque converter remains securely in place on the transmission input shaft while separating and removing the transmission.