Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Transmission Mount Strut Bracket (2) @ Vehicle - Install

CAUTION:

This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

CAUTION:

Fastener Caution

Transmission Mount Strut Bracket Bolt (1) @ Transmission - Install NEW and tighten [3x]
1. First Pass: 100 N.m (74 lb ft)
2. Final Pass: 90 - 105 degrees
Courtesy of GENERAL MOTORS COMPANY

Transmission Mount Strut Bolt-Powertrain Side (1) - Install and tighten
1. First Pass: 100 N.m (74 lb ft)
2. Final Pass: 60 - 75 degrees
Courtesy of GENERAL MOTORS COMPANY

Engine Mount Brace (1) - Install - Engine Mount Brace Replacement (Rear)
Courtesy of GENERAL MOTORS COMPANY

Front Compartment Insulator (1) - Install - Front Compartment Insulator Replacement (Base)