Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Position the transmission control assembly to the transmission control base.
Courtesy of GENERAL MOTORS COMPANY

Push the transmission control assembly (1) downward and forward to seat it to the transmission control base.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Ensure the flats of the bolt align with the transmission control assembly flat points inside the base before tightening the nut.

Install the main shaft bolt (1).
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution .

NOTE:
When installing the transmission control main shaft bolt, the face of the bolt must be held in the slot of the mounting bracket as the nut is torqued to ensure it remains seated and doesn't rotate out of the slot. Failure to perform this task can result in a loose shifter feel, squeaks & rattles, or excessive cross car lash resulting in a customer's poor perceived quality of the system.

Install the main shaft bolt nut and washer (1) to the transmission control assembly and tighten to 7 N.m (62 lb in).
Connect the transmission control electrical connector.
Automatic Transmission Range Selector Lever Cable @ Transmission Control - Connect - Automatic Transmission Range Selector Lever Cable Replacement
Front Floor Console - Install - Front Floor Console Replacement
Release the park brake.
Range Selector Lever Cable - Adjust - Range Selector Lever Cable Adjustment