LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Trailblazer RS, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - VT40 (MRG) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Control Lever Knob Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5421820Courtesy of GENERAL MOTORS COMPANY

    Transmission Control Lever Boot (2) @ Transmission Control Lever (3) - Install

  2. Transmission Control Lever Knob (1) @ Transmission Control Lever - Install
  3. GM5421819Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure the correct orientation of the transmission control lever knob fastener.

    Transmission Control Lever Knob Fastener (2) - Install

  4. Install the transmission control lever knob cover (1).
  5. Check the transmission control lever knob for proper seat by pulling and twisting.
  6. GM5421821Courtesy of GENERAL MOTORS COMPANY

    Pull the transmission control lever boot bezel (1) along with the transmission control lever boot retaining ring (2) up.

  7. Install the transmission control lever boot retaining ring to the transmission control lever knob. The 2 latches (arrows) of the transmission control lever boot retaining ring must engage noticeable.
  8. Push the transmission control lever boot bezel down.
  9. GM5421817Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector (1) - Connect

  10. GM5421816Courtesy of GENERAL MOTORS COMPANY

    Insert the rear locating tab (1) into the front floor console.

  11. Seat the retainers (arrows) of the bezel into the front floor console.
  12. Turn the ignition switch to On position, engine Off.
  13. Place transmission control in the Park position.
  14. Un-apply the parking brake.
  15. Turn the ignition switch to the Off position.
scientia non olet · About LEMON Manuals