Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Prepare the range selector lever cable bolt (2) for installation as follows:
- Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
- Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
- Apply thread locking adhesive to the external threads of the component.
- Ensure there are no gaps in the thread locking adhesive once applied to the component.
- Install the range selector lever cable to vehicle by installing it from the interior.
Range Selector Lever Cable (3) @ Transmission Control - Install
- Install the 2 range selector lever cable bolts (1, 2) and tighten to 9 N.m (80 lb in).
Transmission Range Selector Lever Cable Grommet Nut (1) - Install and tighten [2x] 9 N.m (80 lb in)
- Front Floor Console - Install - Front Floor Console Replacement
Automatic Transmission Range Selector Lever Cable (4) @ Range Selector Lever Cable Lever - Install
- Automatic Transmission Range Selector Lever Cable Bolt (1) - Install and tighten 9 N.m (80 lb in)
- Depress the cable adjustment retainer (3) locking the retainer completely.
- Slide the retainer lock (2) rearward to cover the cable adjustment retainer (3).
- Range Selector Lever Cable - Adjust - Range Selector Lever Cable Adjustment
Wiring Harness Retainer (1) @ Battery Tray - Install
- Air Cleaner Assembly - Install
- {With LIH} Air Cleaner Assembly Replacement
- {With L3T} Air Cleaner Assembly Replacement
CAUTION: