Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Vacuum Pump Gasket (3) - Install NEW
Vacuum Pump (2) - Install
Vacuum Pump Bolt (3) - Install and hand tighten [3x]
Fig 1: Identifying Vacuum Pump Bolts With Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Vacuum Pump Bolt (1) - Tighten in sequence [3x]
1. First Pass: 7 N.m (62 lb in)
2. Final Pass: 15 N.m (11 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Wastegate Actuator Vacuum Control Solenoid Valve Hose (1) @ Vacuum Pump - Install
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Coolant Return Pipe - Install - Turbocharger Coolant Return Pipe Replacement (LIH)
Charge Air Cooler Inlet Air Hose - Install - Charge Air Cooler Inlet Air Hose Replacement
Air Cleaner Outlet Rear Duct - Install - Air Cleaner Outlet Rear Duct Replacement
Air Cleaner Assembly - Install - Air Cleaner Assembly Replacement
Courtesy of GENERAL MOTORS COMPANY

Intake Manifold Cover - Install
Fill the cooling system to the proper level. Cooling System Draining and Filling (GE-47716) , or Cooling System Draining and Filling (Static)
Start the engine and check for leaks.