Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Fuel Pump Housing Seal (1) - Install NEW
- Fuel Pump (2) - Install
- Fuel Pump Bolt (3) - Install and tighten [2x] 36 N.m (27 lb ft)
Electrical Connector (1) @ Fuel Pump (2) - Connect
Fuel Feed Intermediate Pipe - Install
Fuel Pump Cover - Install
- Charge Air Cooler Inlet Air Hose - Install - Charge Air Cooler Inlet Air Hose Replacement
Fuel Feed Front Pipe - Install
- Inspect for fuel leaks using the following procedure:
- Turn ON the ignition with the engine OFF for 2 seconds.
- Turn OFF the ignition for 10 seconds.
- Turn ON the ignition with the engine OFF.
- Inspect for fuel leaks.
NOTE:
The fuel pump flange must be fully seated to the cylinder head.
CAUTION:
Alternately hand-tighten the fuel pump bolts one turn at a time until the pump is fully seated. Trying to draw down the pump without even side-to-side tightening may result in pump plunger damage.
CAUTION: