Installation Procedure
Fuel/gasoline vapors are highly flammable. A fire could occur if an ignition source is present. Never drain or store gasoline or diesel fuel in an open container, due to the possibility of fire or explosion. Have a dry chemical (Class B) fire extinguisher nearby.
Wrap a shop towel around the fuel pressure connection in order to reduce the risk of fire and personal injury. The towel will absorb any fuel leakage that occurs during the connection of the fuel pressure gauge. Place the towel in an approved container when the connection of the fuel pressure gauge is complete.
Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:
- The fuel pipe connections
- The hose connections
- The areas surrounding the connections
- Relieve the fuel system pressure. Fuel Pressure Relief
- Disconnect the quick connect coupling of the fuel feed front pipe from the fuel feed intermediate pipe at the front of dash. Use a shop towel in order to catch any remaining fuel that may leak. Plastic Collar Quick Connect Fitting Service
- Install the CH-37287-1A adapter (2) between the fuel feed front pipe and the fuel feed intermediate pipe.
- CAUTION:
Refer to Component Fastener Tightening Caution .
Install the J-34730-1A gauge (1) to the CH-37287-1A adapter (2), and tighten securely.
- Turn ON the ignition in order to pressurize the fuel system.
- Turn OFF the ignition.
- Check for any fuel leaks.