Installation Procedure
WARNING: This page is about a different variant/trim than selected.
The EN-52443 High Pressure Fuel Pump Alignment Tool has two ends marked with Number 1 (1) and Number 2 (2).
- NOTE:
- The camshaft MUST be at the base circle position before the fuel pump is installed.
- At the base circle position, the EN-52443 High Pressure Fuel Pump Alignment Tool will sit flush with the cylinder head.
Install the EN-52443 High Pressure Fuel Pump Alignment Tool (2) with the Number 1 (1) on the outside and turn the crankshaft until the camshaft lobe is at the base circle position.
- Remove the EN-52443 High Pressure Fuel Pump Alignment Tool (2).
Lubricate the fuel injection pump shaft lifter roller (1) with engine oil. Adhesives, Fluids, Lubricants, and Sealers
- Fuel Injection Pump Shaft Lifter Roller (1) - Install
Fuel Pump (2) - Install
- Inspect for fuel leaks using the following procedure:
- Turn ON the ignition with the engine OFF for 2 seconds.
- Turn OFF the ignition for 10 seconds.
- Turn ON the ignition with the engine OFF.
- Inspect for fuel leaks.