Removal Procedure

WARNING: This page is about a different variant/trim than selected.

WARNING:

WARNING:

Relieve the fuel system pressure. Fuel Pressure Relief
Battery Tray - Remove - Battery Tray Replacement
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) @ Electronic Brake Control Module (2) - Disconnect
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Cap the brake pipe fittings to prevent brake fluid loss and contamination.

Brake Pipe Fitting (1) @ Brake Pressure Modulator Valve - Remove [4x]
Courtesy of GENERAL MOTORS COMPANY

Fuel Feed Pipe-Underbody (1) @ Fuel Feed Front Pipe (2) - Disconnect - Metal Collar Quick Connect Fitting Service
Fuel Feed Pipe-Underbody (1) @ Retainer (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

Fuel Feed Pipe-Underbody (1) @ Retainer (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Fuel Feed Front Pipe Shield (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Fuel Feed Pipe-Underbody (1) @ Retainer (2) - Remove [3x]
Raise and support the vehicle. Lifting and Jacking the Vehicle
Remove the left front tire and wheel assembly. Tire and Wheel Removal and Installation
Courtesy of GENERAL MOTORS COMPANY

Fuel Feed Pipe-Underbody (1) @ Retainer (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Fuel Feed Pipe-Underbody (1) @ Fuel Feed Pipe-Fuel Tank (2) - Disconnect - Plastic Collar Quick Connect Fitting Service
Courtesy of GENERAL MOTORS COMPANY

Fuel Feed Pipe-Underbody (1) @ Retainer (2) - Remove [5x]
Fuel Feed Pipe-Underbody (1) @ Vehicle - Remove