Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Fuel Feed Intermediate Pipe (3) - Install NEW
- Fuel Feed Intermediate Pipe Nut (1) - Loosely install [2x]
- Fuel Feed Intermediate Pipe Bolt (2) - Install and tighten 8.5 N.m (75 lb in)
- Component Fastener Tightening Caution
Fuel Feed Intermediate Pipe Nut (1) - Tighten 30 N.m (22 lb ft) [2x] [2x]
Fuel Pump Cover - Install - Fuel Pump Cover Replacement
- Air Cleaner Assembly - Install - Air Cleaner Assembly Replacement
- Inspect for fuel leaks using the following procedure:
- Turn ON the ignition with the engine OFF for 2 seconds.
- Turn OFF the ignition for 10 seconds.
- Turn ON the ignition with the engine OFF.
- Inspect for fuel leaks.
CAUTION: