Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Pipe-Underbody (1) @ Vehicle - Install
Evaporative Emission Pipe-Underbody (1) @ Retainer (2) - Install [5x]
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Pipe-Underbody (1) @ Evaporative Emission Pipe-Fuel Tank (2) - Connect - Plastic Collar Quick Connect Fitting Service
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Pipe-Underbody (1) @ Retainer (2) - Install
Install the left front tire and wheel assembly. Tire and Wheel Removal and Installation
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Pipe-Underbody (1) @ Retainer (2) - Install [3x]
Courtesy of GENERAL MOTORS COMPANY

Fuel Feed Front Pipe Shield (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Pipe-Underbody (1) @ Retainer (2) - Install
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Pipe-Underbody (1) @ Retainer (2) - Install [3x]
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Pipe-Underbody (1) @ Evaporative Emission Canister Purge Pump (2) - Connect - Plastic Collar Quick Connect Fitting Service
Courtesy of GENERAL MOTORS COMPANY

Brake Pipe Fitting (1) @ Brake Pressure Modulator Valve - Install and tighten [4x] 18 N.m (13 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) @ Electronic Brake Control Module (2) - Connect
Battery Tray - Install - Battery Tray Replacement
Bleed the brake system. Hydraulic Brake System Bleeding (Pressure)