Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- The positive crankcase ventilation vacuum hose clamps are tamper-proof connections.
- The turbocharger must be removed in order to install the positive crankcase ventilation vacuum hose at the turbocharger.
- The camshaft cover, turbocharger, and vacuum hose can be removed together as an assembly and set aside so long as the tamper-proof connection remains intact.
- The camshaft cover or turbocharger can be removed and set aside so long as the vacuum hose connection remains intact and undamaged.
- Direct Fuel Injection Fuel Rail - Remove - Direct Fuel Injection Fuel Rail Replacement
EN-52433 Injector Remover (2) @ EN-51146-1-3 slide hammer (1) - Assemble
- EN-52433 Injector Remover (2) @ Fuel Injector (3) - Install
- Direct Fuel Injector (3) - Remove [3x] - Use EN-51146-1-3 slide hammer
- Remove the special tools.
Fuel Injector Seal Retainer - White (1) - Remove [3x]
- Fuel Injector Seal Retainer - Red (2) - Remove [3x]
- Combustion Fuel Injector Seal (3) - Remove and DISCARD [3x]
NOTE:
DO NOT remove the positive crankcase ventilation vacuum hose unless replacement of the hose is necessary.