Camshaft Position Actuator Solenoid Valve Replacement - Intake

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Camshaft Position Actuator Solenoid Valve Bolt [2x] CAUTION: Refer to Fastener Caution . Tighten 8.5 N.m (75 lb in)
2	Camshaft Position Actuator Solenoid Valve Procedure Disconnect the camshaft position actuator solenoid valve electrical connector.
3	Camshaft Position Actuator Solenoid Valve Seal Procedure DISCARD and install NEW. Apply a small amount lubricant to the camshaft position actuator solenoid valve seal ONLY. Adhesives, Fluids, Lubricants, and Sealers

Callout

Component Name

Camshaft Position Actuator Solenoid Valve Bolt [2x]

CAUTION:

Tighten
8.5 N.m (75 lb in)

Camshaft Position Actuator Solenoid Valve
Procedure
Disconnect the camshaft position actuator solenoid valve electrical connector.

Camshaft Position Actuator Solenoid Valve Seal

Procedure

DISCARD and install NEW.
Apply a small amount lubricant to the camshaft position actuator solenoid valve seal ONLY. Adhesives, Fluids, Lubricants, and Sealers