Reverse Clutch Spring Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Reverse Clutch Spring NOTE: Ensure spring is centered.
2	Reverse Clutch Spring Retaining Ring Procedure NOTE: Ensure the retaining ring is engaged fully under slotted covering. Use the DT-52315 Reverse Clutch Spring Compressor to install the reverse clutch spring retaining ring. Apply downward pressure to the reverse clutch spring to allow the reverse clutch spring retaining ring to seat fully in groove. Special Tools DT-52315 Reverse Clutch Spring Compressor Equivalent regional tools: Special Tools

Callout

Component Name

Reverse Clutch Spring

NOTE:

Ensure spring is centered.

Reverse Clutch Spring Retaining Ring

Procedure

NOTE:

Ensure the retaining ring is engaged fully under slotted covering.

Use the DT-52315 Reverse Clutch Spring Compressor to install the reverse clutch spring retaining ring.
Apply downward pressure to the reverse clutch spring to allow the reverse clutch spring retaining ring to seat fully in groove.

Special Tools
DT-52315 Reverse Clutch Spring Compressor
Equivalent regional tools: Special Tools