Holding Fixture Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Transmission Case WARNING: Handle with care, the transmission assembly weighs over 90.7 kg (200 lbs). Bodily injury could occur if not handled properly. Procedure Raise the transmission with an overhead hoist in order to install the holding fixture. CAUTION: Refer to Fastener Caution . Adjust mounting block on DT-46625 Transmission Holding Fixture to match bosses on case Tighten 13 N.m (10 lb ft) Ensure the DT-3289-20 Holding Fixture is mounted to a bench that is properly supported and will support the weight of the transmission assembly without tipping. Install lock pin for DT-3289-20 Holding Fixture. Special Tools DT-3289-20 Holding Fixture DT-46625 Transmission Holding Fixture DT-46625-30 Transmission Holding Fixture Adapter Equivalent regional tools: Special Tools .

Callout

Component Name

Transmission Case

WARNING:

Handle with care, the transmission assembly weighs over 90.7 kg (200 lbs). Bodily injury could occur if not handled properly.

Procedure

Raise the transmission with an overhead hoist in order to install the holding fixture.

CAUTION:

Adjust mounting block on DT-46625 Transmission Holding Fixture to match bosses on case
Tighten

13 N.m (10 lb ft)
Ensure the DT-3289-20 Holding Fixture is mounted to a bench that is properly supported and will support the weight of the transmission assembly without tipping.
Install lock pin for DT-3289-20 Holding Fixture.

Special Tools

Equivalent regional tools: Special Tools .