Automatic Transmission Wiring Harness Installation
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | Automatic Transmission Wiring Connector Seal Procedure
NOTE:
To prevent damage to the seal during installation, apply assembly grease to the harness connector prior to installation. Install a NEW seal. Do NOT reuse the old seal. |
| 2 | Automatic Transmission Wiring Harness
NOTE:
Ensure all retaining clips are installed properly. |
| 3 | Wiring Harness Bracket Bolt [3x] M6 x 25
CAUTION:
Refer to Fastener Caution . Tighten 9 N.m (80 lb in) |