Automatic Transmission Output Speed Sensor Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Automatic Transmission Output Speed Sensor Procedure Install the output speed sensor Connect the output speed sensor connector.
2	Automatic Transmission Speed Sensor Bolt M6 x 25 CAUTION: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. CAUTION: Refer to Fastener Caution . Procedure Install a NEW bolt. Do NOT reuse the old bolt. Tighten First Pass: 4 N.m (35 lb in) Final Pass: 45 degrees Special Tools DT-48285 Torque Socket Equivalent regional tools: Special Tools

Callout

Component Name

Automatic Transmission Output Speed Sensor
Procedure

Install the output speed sensor
Connect the output speed sensor connector.

Automatic Transmission Speed Sensor Bolt M6 x 25

CAUTION:

This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

CAUTION:

Refer to Fastener Caution .

Procedure
Install a NEW bolt. Do NOT reuse the old bolt.
Tighten

First Pass: 4 N.m (35 lb in)
Final Pass: 45 degrees

Special Tools
DT-48285 Torque Socket
Equivalent regional tools: Special Tools