Circuit/System Description

WARNING: This page is about a different variant/trim than selected.

For an overview of the component/system, refer to Electronic Component Description

Circuit	Description
B+	Supplied from a fuse.
Signal	The control module input circuit has an internal resistance connected to 5 V.
Control	The output circuit is switched to ground to activate the component. The output is PWM controlled.
Ground	Chassis Ground

Component	Description
G5 Transmission Fluid Pump - Electric/Auxiliary	An electric DC motor.
K71 Transmission Control Module	The control module contains a microprocessor used to process input data to control outputs. The control module contains a microprocessor used to process input data to control outputs. The control module receives information from a variety of sensors, switches and serial data information from other control modules. This information is used to control a combination of solenoid valves to obtain the correct line pressure, gear ratio and torque converter clutch operation.

Component

Description

G5 Transmission Fluid Pump - Electric/Auxiliary

An electric DC motor.

K71 Transmission Control Module

The control module contains a microprocessor used to process input data to control outputs. The control module contains a microprocessor used to process input data to control outputs. The control module receives information from a variety of sensors, switches and serial data information from other control modules. This information is used to control a combination of solenoid valves to obtain the correct line pressure, gear ratio and torque converter clutch operation.