Conditions for Running the DTC

Condition 1 under "Setting" correlates with condition 1 under "Running"

• DTCs related to the following system/component = Not Set
  • B107 Accelerator Pedal Position Sensor
  • B14A Transmission Output Shaft Speed Sensor
  • B14C Transmission Input Shaft Speed Sensor
  • B14D Transmission Intermediate Shaft Speed Sensor
  • B26 Crankshaft Position Sensor
  • B303 Transmission Range Sensor
• Q77D Transmission Control Solenoid Valve 4 = Enabled
• Autostart/Autostop = Inactive
• Battery Voltage = Greater than 10 V
• Engine Speed = Greater than 349 RPM
• Ignition = On
• Ignition Voltage = Greater than 10 V
• Transmission Fluid Temperature = Warmer than 20°C (68°F)
• Transmission Range = Drive

Condition 1

• Accelerator Pedal Position = 0%
• Vehicle Speed = 0 km/h (0 MPH)

Condition 2

• Accelerator Pedal Position = Greater than a predefined threshold
• Engine Speed = Greater than 1499 RPM
• Primary Pulley Speed = Greater than 159 RPM

Frequency the DTC runs = Continuously - After the running conditions are met