Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify the condition does not exist: Incorrect fluid level or condition - Refer to Transmission Fluid Level and Condition Check
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- If a condition exists
- Ignition - On / Vehicle - In Service Mode
- Clear DTCs
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify DTC P0961 is not set.
- If DTC P0961 is set
Refer to Diagnostic Fault Information
- Go to next step: If no DTC is set
- If DTC P0961 is set
- All OK.