Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTC P0842, P0843, P0847, P0848, P0962, P0966, P0970 = Not set
Engine Speed = Greater than 899 RPM
Ignition = On
Ignition Voltage = Greater than 9 V
Primary Pulley Pressure Command = 500 to 2000 kPa (73 to 290 PSI)
Secondary Pulley Pressure Command = 500 to 2000 kPa (73 to 290 PSI)

Frequency the DTC runs = Continuously - After the running conditions are met