Conditions for Running the DTC

• DTCs related to the following system/component = Not Set
  • B14A Transmission Output Shaft Speed Sensor
  • B14D Transmission Intermediate Shaft Speed Sensor
  • B26 Crankshaft Position Sensor
• DTC P0842, P0843, P2535 = Not set
• Engine Speed = Greater than 499 RPM
• Ignition = On
• Ignition Voltage = Greater than 9 V
• Primary Pulley Pressure Command = Greater than 499 kPa (72 PSI)

Frequency the DTC runs = Continuously - After the running conditions are met