Conditions for Running the DTC

P0721

• Battery Voltage = Greater than 9 V
• Ignition = On
• Ignition Voltage = Greater than 9 V

Frequency the DTC runs = Continuously - After the running conditions are met

P0722

• DTCs related to the following system/component = Not Set
  • B107 Accelerator Pedal Position Sensor
  • B14C Transmission Input Shaft Speed Sensor
  • B75 Mass Air Flow Sensor
  • Q14 Exhaust Gas Recirculation Valve
  • Q17 Fuel Injector
  • Engine Misfire
  • Fuel Trim System
• Accelerator Pedal Position = Greater than a predefined threshold
• Battery Voltage = Greater than 9 V
• Engine Speed = Greater than 349 RPM
• Engine Torque = Greater than a predefined threshold
• Ignition = On
• Ignition Voltage = Greater than 9 V
• Transmission Input Speed = Greater than 299 RPM
• Transmission Range = D

Frequency the DTC runs = Continuously - After the running conditions are met

P0723

• DTCs related to the following system/component = Not Set
  • B107 Accelerator Pedal Position Sensor
  • B14C Transmission Input Shaft Speed Sensor
  • B75 Mass Air Flow Sensor
  • Q14 Exhaust Gas Recirculation Valve
  • Q17 Fuel Injector
  • Engine Misfire
  • Fuel Trim System
• Engine Speed = Greater than 349 RPM
• Transmission Input Speed = Greater than 399 RPM

Frequency the DTC runs = Continuously - After the running conditions are met

P077C, P077D

• Battery Voltage = Greater than 10 V
• Ignition = On
• Ignition Voltage = Greater than 10 V

Frequency the DTC runs = Continuously - After the running conditions are met