Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0716
- DTCs related to the following system/component = Not Set
- B75 Mass Air Flow Sensor
- B107 Accelerator Pedal Position Sensor
- Q14 Exhaust Gas Recirculation Valve
- Q17 Fuel Injector
- DTC P0171, P0172, P0174, P0175, P11E9, P11EA, P11EB, P11EC, P2178, P2179, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0717, P07BF, P07C0 = Not set
- Accelerator Pedal Position = Greater than 5%
- Battery Voltage = Greater than 9 V
- Engine Speed = Greater than 349 RPM
- Engine Torque = 30 to 8, 191 Nm (22 to 6, 041 lb ft)
- Ignition = On
- Ignition Voltage = Greater than 9 V
- Transmission Input Speed = 50 to 170 RPM
Frequency the DTC runs = Continuously - After the running conditions are met
P0717
- DTCs related to the following system/component = Not Set
- B14A Transmission Output Shaft Speed Sensor
- B75 Mass Air Flow Sensor
- Q14 Exhaust Gas Recirculation Valve
- Q17 Fuel Injector
- DTC P0171, P0172, P0174, P0175, P11E9, P11EA, P11EB, P11EC, P2178, P2179, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0716, P07BF, P07C0 = Not set
- Accelerator Pedal Position = Greater than 5%
- Battery Voltage = Greater than 9 V Battery Voltage
- Brake Pedal Position = Less than 70%
- Engine Torque = 30 to 8, 191 Nm (22 to 6, 041 lb ft)
- Ignition = On
- Ignition Voltage = Greater than 9 V
- Transmission Input Speed = Greater than 320 RPM
- Transmission Output Speed = Greater than 67 RPM
Frequency the DTC runs = Continuously - After the running conditions are met
P07BF, P07C0
- Battery Voltage = Greater than 10 V
- Ignition = On
- Ignition Voltage = Greater than 9 V
Frequency the DTC runs = Continuously - After the running conditions are met