Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0711
- DTCs related to the following system/component = Not Set
- B14A Transmission Output Shaft Speed Sensor/B115 Vehicle Speed Sensor
- B26 Crankshaft Position Sensor
- B34 Engine Coolant Temperature Sensor
- B74 Manifold Absolute Pressure Sensor
- B75 Mass Air Flow Sensor
- B107 Accelerator Pedal Position Sensor
- Q14 Exhaust Gas Recirculation Valve
- Q17 Fuel Injector
- DTC P0300, P0301, P0302, P0303, P0304, P0712, P0713, P0171, P0174, P11E9, P11EA, P11EB, P11EC, P2178, P2179, P2818 = Not set
- Accelerator Pedal Position = Greater than 5%
- Battery Voltage = Greater than 9 V
- Engine Coolant Temperature = -40 to 150°C (-40 to 302°F)
- Engine Speed = Greater than 500 RPM
- Ignition Voltage = Greater than 9 V
- Transmission Fluid Temperature Sensor = -40 to 150°C (-40 to 302°F)
- Vehicle Speed = Greater than 10 km/h (6 MPH)
Frequency the DTC runs = Continuously - After the running conditions are met
P0712, P0713
- Battery Voltage = Greater than 9 V
- Ignition = On
- Ignition Voltage = Greater than 9 V
Frequency the DTC runs = Continuously - After the running conditions are met