Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify DTC P0641, P0651, P0697, P06A3, P06D2, P2805 is not set.
- If DTC P0641, P0651, P0697, P06A3, P06D2 is set
- If DTC P2805 is set
Replace the component: B303 Transmission Range Sensor
- Go to next step: If DTC P0641, P0651, P0697, P06A3, P06D2, P2805 is not set
- Verify the condition does not exist: Incorrect adjustment - Transmission Range Selector Lever Cable - Refer to Range Selector Lever Cable Adjustment
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- If a condition exists
- Ignition - On / Vehicle - In Service Mode
- Operate the component: S3 Transmission Shift Lever - Select each position
Verify the scan tool parameter: Transmission Range Sensor 1, 2 = The value should be within the range listed in the table: Transmission Range Sensor Duty Cycles
- If not in the specified range
Refer to Circuit/System Testing
- Go to next step: If in the specified range
- If not in the specified range
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.