LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Trailblazer RS, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.2L (LIH)) >> Repair Instructions >> Lower Oil Pan Installation

Lower Oil Pan Installation

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    DO NOT allow cleaning solvents to come in contact with the oil pump belt.

  1. Clean all sealing surfaces.
  2. GM5294849Courtesy of GENERAL MOTORS COMPANY
    3. NOTE:
    • Ensure proper use of room temperature vulcanizing (RTV) sealant. - Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant 
    • All sealing surfaces must be free of contamination prior to applying the sealant.
    • Installation and final torque specification must be completed within 10 minutes after applying the sealant.
  3. Apply a 4 mm (0.16 in) bead of sealant (1) to the lower crankcase extension. - Adhesives, Fluids, Lubricants, and Sealers 
  4. GM5275612Courtesy of GENERAL MOTORS COMPANY

    Lower Oil Pan (1) - Install NEW

  5. Fig 1: Identifying Lower Oil Pan Bolts With Tightening Sequence
    GM5294856Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Fastener Caution

    Lower Oil Pan Bolt (1) - Install [12x]

  6. Lower Oil Pan Bolt (1) - Tighten in sequence [12x] 8.5 N.m (75 lb in)
  7. GM5275607Courtesy of GENERAL MOTORS COMPANY

    Oil Pump Flow Control Valve Seal (3) - Install NEW

  8. Oil Pump Flow Control Solenoid Valve (1) - Install
  9. Oil Pump Flow Control Solenoid Valve Bolt (2) - Install and tighten 8.5 N.m (75 lb in)
scientia non olet · About LEMON Manuals