Intake Manifold Assemble
WARNING: This page is about a different variant/trim than selected.
Throttle Body Seal (3) @ Intake Manifold - Install NEW
- Throttle Body (4) - Install
- Throttle Body Seal (3) @ Throttle Body Adapter - Install NEW
- Throttle Body Adapter (2) - Install
- Throttle Body Bolt (1) - Install and tighten 8.5 N.m (75 lb in) [3x]
Seal (3) @ Intake Air Pressure and Temperature Sensor - Install NEW
- Intake Air Pressure and Temperature Sensor (2) - Install
- Manifold Absolute Pressure Sensor Bolt (1) - Install and tighten 8.5 N.m (75 lb in)
NOTE:
Ensure the locating pins at the intake manifold seat correctly in the throttle body.
NOTE:
Ensure the locating pin at the throttle body adapter seats correctly in the throttle body.
CAUTION: